Difference between revisions of "EBroidery-Blink-All"
From Digipool-Wiki
(Created page with "<pre> // eBroidery Blink All int ledPin = 13; // on board int led1 = 2; int led2 = 4; // ... int led11 = 12; void setup() { pinMode(ledPin, OUTPUT); pinMode(led1, OUTPUT...") |
|||
| Line 13: | Line 13: | ||
pinMode(led2, OUTPUT); | pinMode(led2, OUTPUT); | ||
// ... | // ... | ||
| − | pinMode( | + | pinMode(led11, OUTPUT); |
} | } | ||
| Line 21: | Line 21: | ||
digitalWrite(led2, LOW); // Led an | digitalWrite(led2, LOW); // Led an | ||
// ... | // ... | ||
| − | digitalWrite( | + | digitalWrite(led11, LOW); // Led an |
delay(1000); // Led an Zeit | delay(1000); // Led an Zeit | ||
| Line 28: | Line 28: | ||
digitalWrite(led2, HIGH); // Led aus | digitalWrite(led2, HIGH); // Led aus | ||
// ...led3, led4 ... led12 (led14, led15 ... led19) | // ...led3, led4 ... led12 (led14, led15 ... led19) | ||
| − | digitalWrite( | + | digitalWrite(led11, HIGH); // Led aus |
delay(1000); // Led aus Zeit | delay(1000); // Led aus Zeit | ||
} | } | ||
</pre> | </pre> | ||
Latest revision as of 10:37, 13 June 2019
// eBroidery Blink All
int ledPin = 13; // on board
int led1 = 2;
int led2 = 4;
// ...
int led11 = 12;
void setup() {
pinMode(ledPin, OUTPUT);
pinMode(led1, OUTPUT);
pinMode(led2, OUTPUT);
// ...
pinMode(led11, OUTPUT);
}
void loop() {
digitalWrite(ledPin, HIGH); // Led an
digitalWrite(led1, LOW); // Led an
digitalWrite(led2, LOW); // Led an
// ...
digitalWrite(led11, LOW); // Led an
delay(1000); // Led an Zeit
digitalWrite(ledPin, LOW);
digitalWrite(led1, HIGH); // Led aus
digitalWrite(led2, HIGH); // Led aus
// ...led3, led4 ... led12 (led14, led15 ... led19)
digitalWrite(led11, HIGH); // Led aus
delay(1000); // Led aus Zeit
}
